Tools Required
  • Drill (with 3mm drill bit)
  • Impact Driver
  • Level
  • Tape Measure & Pencil
  • Assorted Packers
  • Clamps
  • Stud Finder
  • Phillips Head Screwdriver
Process

1. Mark the centre point of the unit on the wall.

2. Using a stud finder, mark the stud locations on wall.

3. Place support under the marked centre point and check for level.

4. Place unit on stand and mark stud positions on rear of unit.

5. Drill holes in marked stud positions.

6. Turn unit around and line up the pre drilled holes with studs, including the centre point of the unit. Fix unit to the wall.

7. Pull out drawer runners and place drawers into the sideboard. Locking them into place.
Drawers lock once you've heard a click

8. Fix handles into place

Tools Required
  • Drill (with 3mm drill bit)
  • Impact Driver
  • Level
  • Tape Measure & Pencil
  • Assorted Packers
  • Clamps
  • Stud Finder
  • Phillips Head Screwdriver
Process

1. Mark the centre point of the unit on the wall.

2. Using a stud finder, mark the stud locations on wall.

3. Place support under the marked centre point and check for level.

4. Place modules on stand and clamp them together.

5. Fix the modules together.

6. Mark stud positions on the backboard of the unit.

7. Fix unit to wall.

8. Pre drill holes before fixing the benchtop

9. Tightly secure benchtop on unit with clamps.

10. Fix benchtop to unit from underneath through the pre drilled holes.

11. Place shelves inside unit.

12. Attach doors by clipping hinges.

If you require any additional assistance, please do not hesitate to contact us via email: support@ensemble.store